Dropped DJI drone: what to do straight away and what to avoid
A gust of wind, a branch you didn't see, a battery that runs out sooner than expected: it happens to everyone sooner or later. What you do in the minutes after the crash can make the difference between a simple repair and much more serious damage. Here's what to do with a crashed DJI drone (Mini, Air, Mavic, Avata, Neo, Flip).
1. Switch it off and remove the battery
If the drone is still on, switch it off as soon as you pick it up and remove the flight battery. A motor jammed by grass or soil that keeps receiving power overheats and can burn out.
2. Check the battery
Check whether the battery is swollen, cracked, deformed or hot. If it is, don't charge it and don't put it back in the drone: keep it away from flammable materials, outdoors or in a fireproof container, and bring it to us. A damaged lithium battery can catch fire even hours after the impact.
3. Collect the pieces
Pick up propellers, covers, gimbal guards and any fragments: they help us understand where the impact happened. Also check that the microSD card is still in place, because your flight videos are stored there.
4. Checks you can do yourself
- Propellers: even a small chip causes vibrations. If a propeller is damaged, replace the whole set.
- Motors: with the drone off, turn each motor by hand. It should spin freely and silently. If it grates, there's sand or soil inside, or the motor is damaged.
- Arms and body shell: look for cracks, especially near the hinges of the folding arms.
- Gimbal: when you switch on, it should run its calibration and stay level. If it shakes, stays crooked or the app shows "gimbal overload", the gimbal or its flat cable is damaged.
5. Don't fly it again straight away
Even if everything looks fine, after an impact the compass and IMU can be out of alignment and an internal component may have come loose. If the DJI app shows compass, IMU, GPS or sensor errors, don't fly: a second crash in flight can cost far more than the first. If you want to test it, only do a short hover at low altitude, in an open space and away from people.
If it has fallen into water
Take it out of the water, remove the battery straight away and don't switch it on to "see if it works": it's the surest way to short-circuit the board. Don't use a hairdryer and don't put it in rice. Dry the outside with a cloth and bring it to us as soon as you can, especially if it was lake water or salt water: we clean the board before corrosion does any damage.
Do you have DJI Care Refresh?
If your drone has DJI Care Refresh active, it's usually best to use the official service, and we'll help you work that out. With no coverage or out of warranty, getting it repaired in Ticino is often the quickest solution.
DJI drone repair in Ticino
At our lab in Contone we open up the drone, tell you what's wrong and give you a free quote. Gimbal, motors, arms, body shell, batteries and remote controllers: you choose the parts, original or premium. After the repair we calibrate the drone and run a test flight before handing it back to you.
You can bring it to us in Contone by appointment or send it to us from anywhere in Switzerland, with the battery and remote controller. You'll find all the details on the DJI drone repair page, or call us on 091 252 55 50.
i-Lab is an independent repair centre, not affiliated with SZ DJI Technology Co., Ltd. DJI and model names are trademarks of their respective owners.
